JL Audio Slash v2 Series 1000/1v2
JL Audio’s Slash v2 amplifiers aren’t just powerful, they’re smart. As your battery voltage fluctuates while you drive, the Regulated, Intelligent Power Supply™ system maintains steady, consistent power at any impedance between 1.5 
and 4 ohms and at any voltage between 11 and 14.4 volts. You’ll get all the power, all the time, even with a wide range of speaker combinations.
The 1000/1v2 mono amplifier puts out 1,000 watts RMS of clean power to your subwoofer system, and JL Audio’s patented Class-D amp circuitry keeps a tight rein on cone movement. The cast aluminum heatsinks dissipate heat quickly, giving these amps long lifespans and reliable operation. You can stack multiple Slash v2 amps, saving you valuable space in your trunk or cargo area.
JL Audio amps use “differential-balanced inputs” to isolate the signal’s ground from the chassis ground, reducing noise and making Slash v2 amplifiers compatible with almost any system, including most factory radios. Tunable frequency filters and a parametric EQ bass boost give you precise control over your bass sound, and the optional RBC-1 remote lets you dial in the right amount of thump from the front seat.
Details:
- mono subwoofer amplifier
- 1,000 watts RMS x 1 at 1.5 to 4 ohms
- Regulated, Intelligent Power Supply system
- differential-balanced inputs
- variable low-pass filter (40-200 Hz, 12 or 24 dB/octave)
- parametric EQ bass boost (0-15 dB at 20-80 Hz)
- variable infrasonic filter (-24 dB/octave at 15-60 Hz)
- optional wired remote bass boost
- Class-D amplifier design
- MOSFET power and output stages
- speaker- and preamp-level inputs
- preamp outputs
- 4-gauge power and ground leads and a 100-amp fuse recommended — wiring and hardware not included with amplifier
- no on-board fuses — when installing multiple amps in a system, an additional 100-amp in-line fuse between the distribution block and the amplifier is recommended
- 19-3/4″W x 2-5/16″H x 10-1/16″D
- warranty: 2 years
Random Posts